 |
 |
 |
 |
 |
 |
 |
 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Installation Instructions MODEL # 10110 10 FT. HOSE
Easy to install, the Sit & Bathe SITZ BATH
fits most faucets to deliver clean, soothing tap water. |
|
||||||
 |
Remove aerator from your existing faucet on lavatory or tub. If you must use a tool, be careful not to damage fixture. |
|
 |
Replace with fitting (A). Be careful not to cross thread aerator when installing. Hand tighten. |
|
 |
Take the hose end with snap coupler (B) and pull down white ring toward hose. Attach coupler by pushing up onto fitting (A) then release ring. |
|
 |
Raise toilet seat, place frame (C) across toilet bowl. Lower toilet seat and adjust water pressure and temperature. | |
|
To maximize the effectiveness and the soothing relief of the Sit & Bathe SITZ BATH, either sit with your back to the toilet in a traditional manner or reverse the seated position and face the toilet as you would with a bidet. While using the Sit & Bathe SITZ BATH, it is not necessary to flush the toilet to prevent overflowing as the toilet will maintain a constant level. After usage it is suggested that you drain the excess water from the Sit & Bathe SITZ BATH. |
||
|
WARNING: The Sit & Bathe SITZ BATH is for EXTERNAL use ONLY. Check water temperature before using. Hot water will scald. If discomfort, bleeding or unusual discharge occurs consult your physician immediately. Expectant mothers should consult physician before use. |
||
